Audi A3

since 1997 of release

Repair and car operation


Audi A3
+ Maintenance instruction
+ Current leaving and service
+ Engine
- Systems of cooling, heating
   + System of cooling of the engine
   - Systems of ventilation, heating and air conditioning
      General information and security measures
      Removal and installation of air deflectors
      Removal and installation of a nozzle of the region of feet
      Removal and drive installation lamp heater/replacement
      Removal and installation of cables of a drive of management of a heater
      Removal and installation of the fan of fresh air
      Removal and installation of the additional resistor
      Conditioner
      Removal and compressor installation
      Conditioner diagnostics on codes on the display of the block of its management
+ the Power supply system and production of the fulfilled gases
+ engine Electric equipment
+ Manual box of gear shifting
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Elektroskhema

38a8de3e

Removal and drive installation lamp heater/replacement
GENERAL INFORMATION

Illumination of the switch is carried out by a light guide, there is only one filament lamp. For replacement of a lamp remove the fan switch. A lamp take out from the boss flat-nose pliers. Since the middle of 1997 of release replacement by a light-emitting diode (LED) is made. The last is not replaced.

REMOVAL

PERFORMANCE ORDER
1. Remove a radio receiver, address to the subsection Removal, installation and radio receiver coding.
2. Remove an overlay of switches (And).
3. Unscrew 4 screws of fastening (In) the control unit. Thus pay attention to the provision of brackets (C) for the subsequent assembly.
4. Remove the forward central console (D), address to the subsection Removal and installation of the bottom central console.
5. Remove control unit cables, address to the subsection Removal and installation of cables of a drive of management of a heater.
INSTALLATION
6. Fix cables on the control unit and adjust them, address to the subsection Removal and installation of cables of a drive of management of a heater.
7. Establish the forward central console, address to subsection Fusible inserts.
8. Fix a heater drive to the central part of the dashboard the moment of 5 N of m.
9. Establish an overlay of switches.
10. Establish a radio receiver, address to the subsection Removal, installation and radio receiver coding.