Replacement of batteries of a key of remote control
REMOVAL
ATTENTION
At removal of batteries check, whether polarity is specified on batteries. If polarity is not specified, mark position of the battery.
| PERFORMANCE ORDER |
| 1. Insert a screw-driver into a gap between the block of the transmitter-1-and the main key – 2–. |
| 2. Turn a screw-driver in the arrow direction and by that disconnect the transmitter block from a key. |
| 3. Release the transmitter block, having pressed lateral clamps (are specified by shooters). Remove the transmitter block. | | 4. Disconnect the top battery-1-by means of a screw-driver from holders–2–, as shown shooters. | | 5. Take out a contact plate–1–. Thus turn it so that two direct edges adjoined to both clamps. The contact plate can be removed also by means of a screw-driver. | | 6. Disconnect the bottom battery by means of a screw-driver from holders. | | INSTALLATION
ATTENTION At installation of batteries watch polarity. Polarity (+/–) is specified on the battery and the case.
| PERFORMANCE ORDER |
| 1. Insert the bottom battery-4-a positive pole (+) down into the case-5-. The positive pole (+) is specified on the case. | | 2. Put a contact plate–3–on the battery-4-and turn behind clamps. |
| 3. Put the battery-2-a positive pole (+) down on a contact plate and fix. | 4. Put the transmitter-1-block on the case-2-and fix.
ATTENTION The block of the transmitter is shown on an illustration overturned.
|
5. Insert the complete block of the transmitter into the main key–6–and fix.
ATTENTION
The transponder of the variable code designated by the beaten-out letter W has a key.
|
| | |
|
